Beko WMI 71641 Washer User Manual


  Open as PDF
of 48
 
EN
25
Preparation
1. Turn the tap on completely. Check that
the hose is connected tightly.
2. Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1. Pressthe“On/Off”button.
2. SelecttheProgrammeandthe
temperature.
3. Ifdesired(accordingtoyourmachine’s
model):
– selectanyauxiliaryfunction,
– adjustthespinspeed,
– setthetimedelay,
4. Close the loading door.
5. Press“Start/Pause/Cancel”button.
The display shows the time remaining for
theProgrammetocompleteiftimedelay
is not set.
The display shows the time remaining for
theProgrammetostartifthetimedelayis
set.
6. Check if the Door Locked Symbol
lights up on the screen.
TheDoorLockedSymbol(Figure3-2i)will
light up if time delay is not set.
TheDoorLockedSymbol(Figure3-2i)will
fade if time delay is set.
Cancelling a Programme
1. Pressandholdthe“Start/Pause/
Cancel”buttonforabout3seconds;
the Start symbol will start flashing.
2. The machine can discharge all the
water or can take in water for 3 times
at most to cool down the clothes and
complete discharging process.
Adding more laundry
•
This is only possible under the
followingconditions:
– duringtimedelay,
C
Youmayaddorremovelaundryduring
thetimedelay(untiltheProgramme
starts).Atthebeginningofawashing
cycle(machineallowsaddingmore
laundry during a future step only if the
water level is low enough to open the
loading door or if the temperature in
themachineislow).
In order to add laundry after the start-
upoftheProgramme:
1. Press“Start/Pause/Cancel”button.
2. Opentheloadingdoorandputin
more laundry.
3. Close the loading door.
4. Press“Start/Pause/Cancel”button.
Programme is in rinse hold mode
C
This process is shown with the
flashing spin symbol and the standby
symbol which is lit up.
If you wish to spin when the machine is in
thismode:
1. Adjust the spin speed.
2. Press“Start/Pause/Cancel”button.
TheProgrammecontinues,pumpsout
the water and spins.
3. The standby symbol fades out and the
start symbol lights up.
If you want to discharge the water without
spinning:
1. Press“Start/Pause/Cancel”button.
2. The standby symbol fades out and the
start symbol lights up.
3. TheProgrammecontinuesandonly
pumps out the water.
Re-spinning the laundry
The control system for an unbalanced load
can pause the spinning in cases when the
distribution of the laundry in the drum is
not balanced.
Ifyouwanttore-spintheclothes:
1. Distribute the laundry in your machine
for a balanced load.
2. SelectthespinProgramme.
3. Adjust the spin speed.
After the Programme is finished
Programmeindicatorsymbolsonthe
screenwillremainlitaftertheProgramme
isfinished.“End”willappearonthe
screen.
1. Opentheloadingdoorandtakeout
the laundry when the door locked
symbol on the display fades out.
2. Pressthe“On/Off”button.
3. Turn the water tap off.
4. Remove any folds in the rubber seal
on the loading door and check for
debris.
5. Leave the loading door and detergent
drawer open to dry.
6
Quick instructions for daily use
 previous next