Filter
Top Products
43
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws, (bearing setscrews), nonpermanent gas connections (i.e., unions, shutoff valves,
orifices), and grounding connections. Motor and drive belts should be examined. Cracked or seriously
frayed belts should be replaced. Tighten loose V-belts when necessary. Complete operational check of
controls and valves. Complete operational check of ALL safety devices (i.e., door switch, lint drawer switch,
sail switch, burner, and hi-limit thermostat).
C. LUBRICATION
The motor bearings, the idler bearings, and the tumbler bearings are permanently lubricated. NO
LUBRICATION IS NECESSARY.