Filter
Top Products
113610-1 www.amdry.com 25
Data Label Information _______________
When contacting ADC, the information on the data label is
required to ensure proper service/parts assistance. The data
label is located on the left side panel area behind the top
control (access) door.
1. Model Number – This describes the style of dryer and
type of heat (gas, electric, or steam).
2. Serial Number – Allows the manufacturer to gather
information on your particular dryer.
3. Manufacturing Code Number – The number issued
by the manufacturer, which describes all possible options
on your particular model.
4. Type of Heat – This describes the type of heat for your
particular dryer, gas (either natural gas or L.P. gas), electric,
or steam.
5. Heat Input (For Gas Dryers) – This describes the heat
input in British Thermal Units per Hour (Btu/hr).
6. Orifice Size (For Gas Dryers) – Gives the number drill
size used.
7. Electric Service – This describes the electric service
for your particular model.
8. Gas Manifold Pressure (For Gas Dryers) – This
describes the manifold pressure taken at the gas valve
tap.
Manual Reset
Burner Hi-Limit Instructions _________
Phase 7
This dryer was manufactured with a manual reset burner
hi-limit thermostat, which is monitored by the Phase 7
computer. If the burner hi-limit is open prior to the start of the
drying cycle, the dryer will start momentarily and then shut
down, the Phase 7 computer will display “burner HIGH LIMIT
fault” with an audio indication.
If the burner hi-limit opens during a drying cycle, the Phase 7
computer will also display the same error code described
above, along with an audio indication. If the drum temperature
is above 100° F (38° C), the dryer will continue to run with no
heat for 3 minutes or until the drum temperature has dropped
below 100° F (38° C). For non-coin models, the “CLEAR/
STOP” button on the Phase 7 keypad must be pressed to
clear the error condition. For coin models, the “PAUSE” key
must be held down for 3-seconds to clear the fault. The
open burner hi-limit must be reset “manually” prior to the
start of the next cycle.
Mechanical Timer
This dryer was manufactured with a manual reset burner
hi-limit thermostat. If the burner hi-limit is open prior to the
start of the drying cycle, or during the cycle, the dryer will not
recognize the open state of the burner hi-limit and will start or
continue through the drying cycle with no heat. Manual reset
hi-limit must be reset manually.
This hi-temperature condition may be caused due to a
restricted exhaust, poor airflow, or improper burner operation.
The location of the burner hi-limit is on the right side of the
burner box, looking at the burner from the back of the dryer.
Warning
Discontinue power to dryer before attempting to
reset hi-limit.
!