Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
18
70444801
Menu Navigation
The UniLinc
The front-end control allows the user to control
machine operation and programming by pressing
keypads to select options on the display menus and by
navigating between display menus.
The user can navigate the control in the following
Menu to Menu Navigation
The , , and keypads are used to
select the desired menu. Once the menu is selected, the
keypad is used to enter that menu. The
keypad allows the user to return to the previous menu.
ways.
Screen to Screen Menu Navigation
In Screen to Screen Navigation, the or
keypad are used to go from one menu page to the next
(i.e., moving from Alarms [1 of 3] Menu to Alarms
[2 of 3] or Alarms [3 of 3] menus), if a menu cannot fit
entirely on the same page. The Laundry Management
Menu uses this navigation method. Cycle
programming also uses this method.
Menu Navigation with Parameters
Another type of menu is a menu with modifiable
parameters. The and keypads are used to
navigate through the screens. The and
keypads are used to change the valve of the
highlighted item.
An example is the Temperature Menu under Global
Setup. The menu items are positioned vertically, but
the and keypads are used to navigate
through the different items while the and
keypads are used to adjust the values.
Cycle Name and Banner Editing
This Edit Mode is used when a cycle name must be
modified or a banner created. The highlighted box is
moved over the editable item and the keypad is
pressed. The mode can be verified by seeing the first
character in the item with a blinking underscore
underneath. The character can then be changed by
using the and keypads. To enter a space or
delete a character, press the keypad.
The Cycle Name can contain the capital letters “A”
through “Z”, small letters “a” through “z”, the
numbers “0” through “9”, and special characters. The
user can go forward to the next character in the item
by using the keypad. Press the keypad to
go backward a character. If the first character in the
item is selected and the keypad is pressed, the
cursor will go to the last character of the item. Thus,
the cursor will move only within the item when the
horizontal keypads are pressed.
Press the or keypad to exit the Edit Mode.