Filter
Top Products
51
QUICK REFERENCE GUIDE
ELECTRONIC MONITORING CONTROL SYSTEM
Important! To activate the controller
after turning on the control power,
press the reset button.
To set the dry, cool, unload and out
of grain timers:
• Press the dry, cool, unload or
out of grain button
• Press the modify button
• Press the increase or decrease
button to get desired setting
• Press the enter button when
desired setting is reached
To set the load and unload delays:
• Press the load or unload button
• Press the modify button
• Press increase or decrease
button to get desired setting
• Press the enter button when
desired setting is reached
Pressing the increase and decrease
buttons simultaneously will access
the following programming features:
• Safety circuit shutdown log
• Dryer model number
• Fan delay
• BPH factor
• Fill auger options:
a. Center fill auger
b. End fill auger
• Metering roll monitor disabling
feature
• Air switch disabling feature
These features are accessed se-
quentially as listed above. Press the
increase or decrease buttons to
change a setting. Press the enter
button to move from feature to fea-
ture.
Pressing and holding the reset but-
ton for five seconds will access the
following programming features:
• Calendar year setting
• Calendar month setting
• Calendar day setting
• Clock hour setting
• Clock minute setting
• Bushel counter reset
• Batch counter reset
These features are accessed sequen-
tially as listed above. Press the in-
crease or decrease buttons to
change a setting. Press the enter but-
ton to move from feature to feature.
To change the marquee on the
LCD display:
• Press and hold the modify button
while turning on the control power
• Press the increase or decrease
button to change a character
• Press the unload button to move
the cursor to the right
• Press the dry button to move the
cursor to the left
• Press the cool button to delete
a character
• Press enter when the desired
marquee is displayed
To reset the computer to the original
default setting, turn off the computer,
press and hold the green AUX 1 but-
ton and turn on the computer.
NOVRAM will appear on the LCD dis-
play. The year, date, time and min-
utes may be changed now, and the
shutdown history may also be cleared.
Note: If the history is cleared the
dryer model number must be reset or
only the bottom fan will operate (if so
equipped).
Dryer owner and Airstream associates check the Electronic Monitoring Control System.