Filter
Top Products
29
L. IDLER SHAFT PILLOW BLOCK BEARING REPLACEMENT
1. Refer to tumbler wheel replacement on idler assembly page 26.
2. Complete Step #1 through Step #11.
3. Remove both set screws from each pillow block bearing.
4. Remove pillow block bearing from shaft.
5. Reverse this procedure for replacement.
NOTE: Once the shaft assembly has been installed into dryer. Return pillow block bearings to the
marked position and tighten set screws.
6. Refer to basket assembly section page 27 for shaft and basket alignment.
M. DRIVE SHAFT PILLOW BLOCK BEARING REPLACEMENT
1. Refer to tumbler wheel replacement on drive assembly page 25.
2. Complete Step #1 through Step #14.
3. Remove both set screws from each pillow block bearing.
4. Remove pillow block bearings from shaft.
5. Reverse this procedure for replacement.
NOTE: Once the shaft assembly has been installed into dryer. Return pillow block bearing to the
marked position and tighten set screws.
6. Refer to basket assembly section page 27 for shaft and basket alignment.
N. V-BELT ADJUSTMENT (Motor to Drive Axle)
1. Discontinue electrical power to the dryer.
2. Remove the belt guard cover from the rear of the dryer.
3. Loosen the four (4) bolts holding the drive motor mount to the side of the dryer.
4. Loosen the jam nuts on the adjustment screw on the top of the motor mount.
5. Turn the adjustment screw to lower the motor mount (to tighten the belts) or raise the motor mount (to loosen
the belts.)
6. Check the vertical plane of the motor and idler pulleys for parallel adjustment.
7. If realignment is required, loosen motor pulley and bushing, and move motor pulley to proper position.