Filter
Top Products
27
3. Remove the ten (10) 1/4-20 x 1/4 socket button head screws from the perforated basket side.
4. Remove the wrapper assembly.
5. Block the tumbler (basket) assembly in position.
6. Mark the position of the pillow block bearings. Then remove the bolts from the pillow block bearing.
7. Remove the idler shaft assembly through the front of the machine.
8. Remove the cap screws from bushing.
9. Insert cap screws in the tapped removal holes and tighten evenly until bushing becomes loose on shaft.
10. Remove the bushing, tumbler wheel and key.
11. Reverse this procedure for replacement.
I. BASKET ASSEMBLY
NOTE: Dryer must be level prior to tumbler (basket) alignment.
1. Discontinue electrical power to the dryer.
2. Remove the perforated tumbler (basket) panel.
3. Remove wrapper panel to access the drive and idler shaft.
4. Place a level on the shafts to verify if level.
5. Measure distance between tumbler (basket) and wrapper 1/2 to 3/4 gap should be derived.
6. Loosen the eight (8) bolts on the pillow block bearings and turn the adjustment screw clockwise (CW) or
counterclockwise (CCW) to increase or decrease the gap between the tumbler (basket) and wrapper.
7. Measure the length of the adjustment bolts and ALL should be equal.
8. Place a level on the shaft to verify it is level if any adjustment has been made.
9. Check the basket drive belt for proper tension. Adjust if necessary.
10. Replace the wrapper panels.
11. Replace the perforated tumbler (basket) panel.
J. 1-15/16 FLANGE BEARING REPLACEMENT
1. Disconnect electrical power to the dryer.
2. Remove the four (4) bolts securing the bearing cap located in the rear of the dryer. And remove.