Filter
Top Products
14
L. MANUAL RESET THERMOSTAT
This is located inside the dryer in the lint
compartment above the lint screen. This
thermostat senses the heated air after it passes
through the tumbler (basket). If the air
temperature gets too hot, the thermostat will shut
off the burner. The dryer will not run until the air
temperature cools down. At this time, the manual
reset thermostat must be reset manually or the
24 VAC burner circuit will never be completed.
Tumbler (basket) and blower will run but the dryer
will not heat. If the temperature sensor opens the
display will read TEMP SENSOR FAIL CHECK
TEMP SENSOR FUSE with an audio indication.
If the thermostat opens the display will read
dRUM SAFETY FAIL with an audio indication.
M. LINT SCREEN
The lint screen is located in the front of the dryer in the Lint
Coop Assembly. To clean the lint off the screen simply
brush the screen clean. The lint screen must be kept clean
in order for the dryer to operate properly and efficiently.
Inspect the screen for tears and replace as needed.
N. LINT DRAWER SWITCH
The lint door switch is located in the lint
compartment and attached to the side of the
lint coop. The lint door switch ensures that
the dryer will operate only when the lint door
is completely closed. This is a safety device
and should never be disabled.