A SERVICE OF

logo

C-7
Apppendix C: CSE-M34S/CSE-M34T Mobile Rack Speciî‚¿cations
Installation Procedures
Installing the CSE-M35S Backplane
SCSI IDs are assigned automatically by the backplane. 1. Do not set IDs man-
ually on the drives. See the previous section for SCSI ID jumper settings.
SCSI termination is enabled by default on the SCSI backplane.2.
Accessing Hot-Swappable Drives
Push the release button located beside each drive's LED.1.
Lift up on the drive's handle. 2.
Carefully pull the drives out of the storage module.3.
Release Buttons
1
2
3
Figure C-3: Releasing the Drives
Figure C-4: Removing the Drives