4-1
Chapter 4: Chassis Setup and Maintenance
Chapter 4
Chassis Setup and Maintenance
4-1 Overview
This chapter covers the steps required to install components and perform mainte-
nance on the chassis. The only tool you will need to install components and perform
maintenance is a Phillips screwdriver. Print this page to use as a reference while
setting up your chassis.
The SC743 i series chassis models do not come equipped with hot-swappable hard
drives. Chassis models in the i series, such as SC743-665, SC743i-500 and SC743i-
465 must be powered-down prior to removing the hard drives. See the instructions
in this section for details on how to remove and install xed hard drives.
All other SC743 chassis models include hot-swappable hard drives which may be
replaced without powering down the system. See the instructions in this chapter for
details on how to install and remove hot-swappable hard drives.
Review the warnings and precautions listed in
the manual before setting up or servicing this
chassis. These include information in Chapter
2: System Safety and the warning/precautions
listed in the setup instructions.
