164 Summit Client Configuration
MX5X Reference Guide E-EQ-MX5CERG-F-ARC
Config/Profile Parameters
Parameter Default Explanation
Config or Edit Profile Default A string of 1 to 32 alphanumeric characters,
establishes the name of the profile.
Options are Default or ThirdPartyConfig.
SSID Blank A string of up to 32 alphanumeric characters.
Establishes the Service Set Identifier (SSID) of the
WLAN to which the client connects.
Client Name Blank A string of up to 16 characters. The client name is
assigned to the network card and the device using
the network. The client name may be passed to
networking wireless devices, e.g. Access Points.
Power Save Fast Power save mode is On.
Options are: Constantly Awake Mode (CAM) power
save off, Maximum (power saving mode) and Fast
(power saving mode).
Tx Power Maximum Maximum setting regulates Tx power to the Max
power setting for the current regulatory domain.
Options are: Maximum, 50mW, 30mW, 20mW,
10mW, 5mW or 1mW. Depending on the version of
the SCU, the options for Tx Power are between
Maximum and 1mW
Bit Rate Auto Setting the rate to Auto will allow the Access Point
to automatically negotiate the bit rate with the
compact flash wireless device.
Options are: Auto, 1 Mbit, 2, 5.5, 6, 9, 11, 12, 18,
24, 36, 48 or 54 Mbit.
Radio Mode BG Optimized
or
BG Rates Full
Specify 802.11g and/or 802.11b when
communicating with the Access Point.
Options are: B rates only, BG Rates full, G rates
only, BG optimized.
Note: Default value may vary depending on
installed SCU driver version.
It is important this parameter correspond to the AP
to which the device is to connect. For example, if
this parameter is set to G rates only, the LXE device
may only connect to APs set for G rates and not
those set for B and G rates.
Auth Type Open 802.11 authentication type used when associating
with the Access Point.
Options are: Open, LEAP, or Shared key.
