A SERVICE OF

logo

Open as PDF
next previous
LXE Diagnostics 119
E-EQ-MX3RG-J-ARC MX3 Reference Guide
Example – Enable COM2 for
Tethered Scanner
The process used to enable the MX3 COM2 port for use with a tethered scanner has three steps:
1. BIOS Setup
• Select Advanced Menu / Select Other / Select COM2 Pin9:
• Change the parameter value to 5V.
• Select Exit Menu / Save and Exit
2. Terminal Emulation Configuration Utility (if used) e.g. ANSI Plus TE:
• Select System Menu / RFFileModeCfg
• Change the parameter value to Comm1 Out, Comm2 In
• Select Exit with Save Option.
3. DOS
• Add the following line to the AUTOEXEC.BAT file on the line above any existing
SETAPI_4 commands:
SETAPI_4 15 ba 56 31 01 x x
Note: If COM1 port is an integrated scanner, the integrated scanner is disabled by this
procedure.