118 Geac System21 commerce.connect: Implementation on the iSeries Server
Figure 5-10 Display Routing Entry Detail display
12.End the SQL server prestart jobs by entering the following command:
ENDPJ SBS(QSYSWRK) PGM(QSQSRVR)
13.Add the storage pool to the QSYSWRK subsystem.
14.Verify whether the QSYSWRK subsystem was already modified by entering the following
command:
DSPSBSD SBSD(QSYSWRK)
15.On the next display, select option 2 to see the pool.
16.On the Display Pool Definitions display (Figure 5-11), if there is a single entry with a pool
ID of 1 and a size of *BASE, then the subsystem was not yet modified in this way. If it was
modified, then determine why and how it was modified before you continue to the next
step.
If you want to continue with this modification, then change the pool ID (2 in this example)
to a number higher than the highest number that is currently in use. Note that this number
is the pool number relative to this subsystem and the system as a whole as shown by
WRKSYSSTS.
Figure 5-11 Display Pool Definitions display for QSYSWRK
Again, the modification was already made using shared pool 2. Therefore, subsystem pool
2 appears. In this case, the subsystem pool number is the same as for QEJBSBS, but this
is not necessary. When started a system pool number, as shown by WRKSYSSTS, will be
