Filter
Top Products
30
Fitting under kitchen worktops
Important: The water supply tap and power outlet
must remain accessible after the appliance is in-
stalled.
Permanent connection
In the case of a permanent connection it is neces-
sary that you install a double pole switch between
the appliance and the electricity supply (mains), with
a minimum gap of 3 mm between the switch con-
tacts and of a type suitable for the required load in
compliance with the current electrical regulations.
The switch must not break the yellow and green
earth cable at any point.
This operation should only be performed by a quali-
fied electrician.
Kitchen with worktops 85 cm high.
The washing machine can be installed in fully fitted
kitchens with continous worktops 85 cm high, after
removing the machine's top cover. This will reduce
the height of the appliance to about 82cm.
To fit the washing machine, an adapter kit is re-
quired. These can be obtained from Customer Serv-
ice.
1 Warning! If removing the top cover to fit the
machine,
– another protective cover must be mounted and,
the appliance must be earthed with special screws
– a replacement trim must be attached to the top
front edge.
Then only should the appliance be connected electri-
cally, and put into operation. The protective cover,
special screws and replacement trim are included in
adapter kit.
Recess size requirements
(Measurements in mm)