Filter
Top Products
25
Where to install
Important! The washing machine must not be oper-
ated in a room where there is a danger of frost. There
is a risk of frost damage or adverse effect on the per-
fomance of the machine. Frost damage is not cov-
ered under the warranty.
• The surface on which the appliance is to be in-
stalled must be firm and level. Do not install the
appliance on carpeted floors or soft floor cover-
ings.
• The surface on which the appliance is to be in-
stalled must be clean and dry and free from
grease, so that the appliance does not slide.
• If the location in which the appliance is to be in-
stalled is fitted with small-format tiles, put a rubber
mat (available in the shops) under the appliance.
If the appliance is to stand on a base:
In order for the appliance to be secure on the base,
fixing plates*) must be mounted, into which the ap-
pliance is inserted.
If the appliance is to stand on a floor
which moves, e.g. a suspended wooden
floor:
Place the appliance in an area as close as possible
to a corner of the room.
Screw a water-resistant wooden board (at least 15
mm thick) onto at least 2 of the floor joists.
Making the appliance level
The four feet of the appliance are pre-adjusted.
Large degrees of unevenness can be compensated
for by individually adjusting the height adjustable
screw feet.
Use the special spanner supplied to do this.
Important! Do not use pieces of wood, cardboard or
such like to level out unevenness in the floor, but ad-
just the height adjustable screw feet instead.