Filter
Top Products
28
Water inlet
A 1.35m long pressure hose is supplied with the ap-
pliance.
If a longer inlet hose is required, only hoses from the
manufacturer are to be used. Your local Service
Force stocks hose kits of different lengths.
3 Sealing rings are either inserted in the plastic
nuts of the threaded hose fitting or are includ-
ed as spare parts. Do not use any other seal-
ing rings.
Important! All threaded hose fittings must only be
tightened by hand.
1.Connect the hose with the right-angle connector to
the machine.
Important! Do not position the inlet hose vertically
downwards. Position it to the right or the left as
shown in the illustration.
2.Connect the hose with the straight connector to a
water tap with an R ¾ (inch) screw thread.
3.Slowly turn on the tap and check that all connec-
tions are watertight.