Filter
Top Products
9
Operating Sequence
Before use
Before using your appliance for the first time, we
recommend you to run a 90°C cotton cycle without
any laundry, to remove any manufacture residue
from the drum and tub:
- Pour 1/2 a measure of detergent into the "detergent
dispenser" and start the machine.
-
Select the "90°C cottons" programme.
-
Press the START/PAUSE button: the wash cy-
cle starts.
1 Load the laundry
• Lift the lid.
• Open the drum by pressing the release button
(A). The 2 flaps will open automatically.
• Shake the laundry out loosely and place into the
drum. Close the drum and shut the lid.
Warning: before closing the lid of your appliance,
ensure that the drum door is properly closed:
• The two flaps are fastened.
• Button A is released (in the raised position).
An electronic system allows the drum to be in the
high position when the cycle is finished. This
system allows for easier loading and unloading of
the laundry. If an unbalanced weight alters the
functionning, turn the drum by hand.
2 Measure out the detergent
Measure out the amount of detergent recom-
mended by the manufacturer in the main wash
compartment
.
If you are carrying out a pre-wash, pour the
detergent into the pre-wash compartment
.
A
DO NOT exceed the maximum level.
3 Add fabric softener
If required, pour fabric softener into the
compartment marked
, without exceeding the
maximum level.
4 Switch the machine on
Press the ON/OFF button to switch the machine
on. The light above the button will light up.
5 Select the desired programme/
fabric
Press the FABRICS button repeatedly in order to
select the desired programme/fabric. The relevant
light will light up.
The lights relevant to the phases which form the
programme will light up.
6 Select the temperature
Press the TEMPERATURE button if you wish to
select a temperature value different from the one
proposed by the washing machine.
The relevant light will illuminate.