Filter
Top Products
20
SYMPTOM
POSSIBLE CAUSE SOLUTION
The machine
vibrates or is noisy.
The internal packing and/or transit bolts
have not been removed.
Remove internal packing/transit bolts.
The wash load is unevenly distributed. See hints and tips section.
The machine is overloaded. Observe the maximum loads quoted for the
programme.
The lid does not
open.
The safety device has locked it. Wait 2 minutes until the relevant light has gone
out.
Unsatisfactory
washing results.
Too little detergent or unsuitable
detergent has been used.
Use the right detergent and the right quantity.
Stubborn stains have not been treated
prior to washing.
Treat the stains before washing.
The correct washing programme/
temperature has not been selected.
Select the correct washing programme/
temperature (see WASHING PROGRAMMES)
Too much laundry has been placed in
the drum.
Observe the maximum loads quoted for the
programme.
Spinning starts are
late or the machine
does not spin.
The electronic unbalance detection
device has cut in because the laundry is
not evenly distributed in the drum. This
may happens several times before the
unbalance disappears and a normal
spinning can resume.
If, after 15 minutes, the laundry is still not
evenly distributed in the drum, the machine will
not spin. In this case, redistribute the load
manually and select the spin programme.