Filter
Top Products
24
Fig. 1
Fig. 2
Fig 4
Fig 6
Fig 3
Fig 5
Unpacking
Packing used to protect internal parts of the
washing machine during transport must be
removed before the washing machine is used
for the first time.
Remove all packing from the washing machine. Tilt
the washing machine sideways and then remove the
packing under the motor, and straighten the washing
machine (fig. 1).
Tilt the washing machine backwards, rotate it by a
quarter of a turn on one of its corners to remove the
transport base (fig. 2).
Open the washing machine lid and remove the
transport packing and plastic films.
Close the lid (fig. 3).
Use a 10 mm spanner to remove the two screws and
spacers at the back (fig. 4).
You can now see the openings that must be closed
with the plugs in the pack attached to the washing
machine; do not forget to fold down the central
capsule (fig. 5).
Make sure that you have removed all these parts
from your washing machine and keep them so that
you can use them again if you need them for future
transport (fig. 6).
If you want to keep your washing machine aligned
with the adjacent furniture, you can cut the pipe
support strip at the back of your washing machine.
Leave the two rectangular side closers in place
(fig. 7).
Positioning
• The installation surface must be clean dry and
level.
• Do not install on deep pile carpet.
• Do not install the appliance in locations where
the temperature may fall below freezing.
• Please ensure that when the appliance is
installed it is easily accessible for the
engineer in the event of a breakdown.
Fig 7