Filter
Top Products
11
13 How to open the lid during the
cycle of the programme
You can open the lid after you have pressed
PAUSE, provided the following conditions exist:
• the appliance is not in the heating phase,
• the level of the water is not high,
• the drum is not turning.
If these requirements are met when you pause
the washing machine, the DOOR light goes out
and the lid can be opened.
Should it not be possible to open the lid, and should
it be absolutely necessary to do so, switch the
appliance off by pressing the ON/OFF button.
After approximately 2 minutes, you can open the
lid.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the lid and press the ON/OFF
button again, the washing machine will resume
the programme from the point where it had been
interrupted.
14 End of programme
At the end of the programme, the washing ma-
chine stops automatically and gives an audible
signal (which can be deactivated, see page 7).
If you had selected the RINSE HOLD option, the
END button is lit to indicate that the water must
be drained (page 8).
The DOOR light goes out at once.
Note:
When you switch the machine on, if you need to
erase the previously performed programme, it is
also sufficient to press the FABRICS button and
select a new programme.
Press the ON/OFF button to switch the machine
off. The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking)
or bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the lid open in order to air the washing ma-
chine.