Filter
Top Products
26
Water Connection
This appliance is designed to be permanently
plumbed into your home's water supply and drai-
nage system.
Water Inlet
Please install the water inlet hose onto the back
of your washing machine :
- Insert the seal in the hole at the bottom of the
back panel (fig. 1).
- Screw on the bottom fitting of the water inlet hose
as shown in fig. 2 and fig. 3.
- Connect the feed hose connector onto the water
inlet tap, taking care to position the gasket
correctly.
- Turn on the water inlet tap.
The water inlet hose cannot be extended. If it is
too short, please contact the After Sales
Department.
Water Drainage
- Assemble the hose holder onto the drain hose.
- Place the assembly in a drainage pipe (or in a
sink) at a height between 70 and 100 cm. Make
sure that it will not fall out.
You must provide an air intake at the end of the
drainage hose, to avoid any water being siphoned.
Important: the drainage hose must not be
extended, on any account. If it is too short, con-
tact a qualified engineer.
Drainage onto a sink outlet spigot :
If the outlet spigot has not been used before,
remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure
with a clip if required, ensure a loop is formed in the
drain hose (see diagram) to prevent waste from
the sink entering the washing machine.
The drain hose may be extended to a maximum of
4 metres. An additional drain hose and joining
piece is available from your local Service Force
Centre. The joining piece must have an internal
diameter of 18 mm.
Important
Before connecting up the machine to new pipework
or to pipework that has not been used for some
time, run off a reasonable amount of water to flush
out any debris that may have collected in the
pipes.