Filter
Top Products
ratchet tooth ratchet tooth
timyg cam a
line up notch
to clear
\ drive lug
ratchet tooth.
4. Insert a narrow, flat-blade
screwdriver under the timing cam
near the clock shaft. Gently lift cam
straight up and off shaft making sure
that the “V-shaped notch clears the
ratchet tooth.
5. Place new cam (hub side down)
over clock shaft Line up flat side of
shaft with flat side of cam hole.
Check that drive lug is in place.
6.
Turn cam until “V-shaped notch
lines up with ratchet tooth.
7. Press cam down in place on motor
shaft. Make sure that “V”-shaped
notch clears the ratchet tooth,
8.
Reattach the timer bracket
assembly; tighten the screws,
9. Repeat steps for other timer
10.
Close and lock the control panel.
Now start...
With dryers in laundry area.
1
n
Check that each leg is
approximately 1 inch from base.
2.
Wipe the interior of the drums
thoroughly with a damp cloth
3.
Install coin vaults and locks (not
supplied) into meter case openings.
4.
Install control panel lock and key (not
supplied).
Electrical Shock Hazard
Control panel must be closed and
locked at all times.
Failure to do so could result in
serious injury or death.
If you wish to change the 45minute
dryer timing cams to either 30- or 60-
minute timing cams, see “To change
to a 30- or 60-minute timing cam,”
Pages 7 and 8. Complete all of the
steps given in that section before
going to Step 6.
Electrical Shock Hazard
Disconnect electrical power at the
service panel (fuse box or circuit
breaker box).
Failure to do so could result in
serious injury or death.
Open control panel and rest it on the
bottom edge of the opening. Attach
slide extension (with flange pointing
down) to one of the coin-slide
mechanisms, Insert the coin-slide
mechanism through the opening to
the left of the control panel.
7.
Secure coin-slide mechanism from
inside the control panel using the
3/l 6” bolt and washer supplied. Install
coin box.
8
n
Repeat Steps 6 and 7 for the other
coin-slide mechanism. Close control
panel.
9..
Insert top of wire guard into holes on
each side of the coin-slide
mechanism. Insert screws through
hooked ends of guard and tighten.
Repeat for other wire guard.
Page 8