Filter
Top Products
Before you start...
Check location where dryers will be
used. Proper installation is your
responsibility The dryer must not be
installed or stored in an area where it
will be exposed to water and/or
weather. Make sure you have
everything necessary for correct
installation.
Each of the dryers is equipped with a
timer, selector switches and indicator
lights. The timers are set to provide 45
minutes (4 pins) of drying time when
activated by the coin slide. Timer
cams for 30-minute (6 pins) and 60-
minute (3 pins) drying timers are
supplied with the unit in the parts
bag. See Pages 7 and 8 for timer
cam changing instructions.
The coin-slide mechanisms, control
panel lock and key, coin box and
coin box locks and keys are not
included and are available from
usual industry sources,
Fire Hazard
For your safety, the information in
this manual must be followed to
minimize the risk of fire or explosion
or to prevent property damage,
personal injury or loss of life.
- Do Not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
l
Do Not try to light any
appliance.
l
Do Not touch any electrical
switch; Do Not use any phone
in your building.
l
Clear the room, building or area
of all occupants.
l
Immediately call your gas
supplier from a neighbor’s
phone. Follow the gas supplier’s
instructions.
- If you cannot reach your gas
supplier, call the fire department.
- Never install dryer up against
draperies or curtains or on carpet.
- Keep any and all items from falling
or collecting behind the dryer.
Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Post this warning in a prominent
location.
It is recommended that the operator
post, in a prominent location,
instructions for the customer’s use in
the event that the customer smells
gas. This information should be
obtained from your local gas supplier.
Page 2
Protection from weather: Proper
operation requires temperatures
above 45°F (7.2”C).
Important: Observe all
governing codes and
ordinances.
The wiring diagram is located inside
the control panel and access panels.
Support: The floor must be able to
l/S-inch-NPT plugged
tapping is required.
See “Gas supply
requirements,” Page 3.
-4
Dryers may be
exhausted from
bottom, rear, left
or right side. See
“Exhaust
requirements,”
Pages 5 - 6.
ded electrical outlet is
-required. See “Electrical
requirements,” Page 4.
support the total weight of 3 15
Location must be large enough to
pounds per unit.
fully open dryer doors. See Page 7 for
Level floor: Maximum floor slope
recessed area requirements and
under dryers - 1 inch.
product dimensions.
Fire Hazard
l
If you install dryers in a garage,
carport, or areas near vehicles
where fumes from gasoline or other
vapors may be present, the vapors
may be heavier than air and
remain near the floor. Place dryers
a minimum of 18 inches above
floor. Check with your building
inspector regarding requirements
for this installation.
Failure to follow these instructions
could result in a fire or explosion.
Electrical Shock Hazard
It is the customer’s responsibility:
l
To contact a licensed electrician.
. To have dryers installed
according to all national and
local codes and ordinances.
Failure to do so could result in a fire,
electrical shock or other personal
injury.
Personal Injury Hazard
More than one person is required to
lift, tilt, or move the dryers because
of their weight and size.
Failure to follow these instructions
may result in personal injury.