Filter
Top Products
Recessed area and
closet Installations
Fire/Health Hazard
Exhaust dryers to the outside to
prevent exposure to substances in
the gas fuels and combustion
byproducts which may be harmful
to your health.
Failire to do so may result in a fire
or health hazard.
L
This appliance may be installed in a
recessed area.
The installation spacing is the
minimum allowable. Additional
spacing should be considered for
ease of installation, servicing and
compliance with local codes and
ordinances.
If closet door is installed, the minimum
unobstructed air openings in the top
and bottom are required. Door must
have two centered openings as
illustrated. Both openings must
provide a minimum of 72 square
inches of unobstructed airflow as
shown. Louvered doors with
equivalent air openings are
acceptable.
FOR CLOSET INSTALLATIONS, TO
PREVENT LARGE AMOUNTS OF LINT
AND MOISTURE FROM
ACCUMULATING, TO MAINTAIN
DRYING EFFICIENCY, AND TO PREVENT
EXPOSURE TO POSSIBLE HEALTH
HAZARDS, DRYERS MUST BE
EXHAUSTED OUTDOORS.
+
4
0”
Additional
clearances may
be required for
wall. door and
floor moldings if
external exhaust
elbow is used.
Recessed front view
Side view
Additional
space may
be needed
for exhaust
elbow.
Closet view
Additional
clearances for
wall, door and
floor moldings
may be
required.
I- 7”
Opening is
minimum for
closet door.
Louvered
door with
equivalent air
openings is
acceptable.
Front view
Companion appliance spacing
should be considered.
No other fuel-burning appliance may
be installed in the same closet.
Product dimensions
Side view
approx.
r
Rear view
pJ
llB/
kttom exhaust
To change to a
30- or 60-minute
timing cam
Electrical Shock Hazard
Disconnect both power supply
cords from the electric power
supply before making these
changes. Change timing cams
before completing electrical
connection.
Failure to follow these instructions
may result in electrical shock or
personal injury.
Each dryer is equipped with a 45
minute timer cam that provides 45
minutes of drying time when
activated by the coin slide.
You can install the 30-minute or 60-
minute timing cam (shipped with
each dryer) as follows:
1.
Unlock control panel. Lift up and
rotate out from cabinet. Control
panel WIII
STIII
De attached to cabinet.
2. Reach into control panel area. Use
a Phillips screwdriver to loosen (but
not remove) timer mounting bracket
screw. Lift up to remove timer
assembly and bracket from cabinet.
ratchet tooth
3. Turn the timing cam by hand until
the ‘I/“-shaped notch lines up below
the ratchet tooth.
Page 7