Filter
Top Products
If dryers do not
operate properly...
Check the following to be sure that:
1. Electrical supply is connected.
2. Circuit breakers are not tripped or
fuses blown.
3. Doors are closed.
4. Timer has been actuated,
5. Controls are set in a running or
“ON” position.
6. Gas shutoff valves are open both
on dryer and supply line.
Move dryers to a
new location...
Floor Damage
Slide dryers onto cardboard or
hardboard before moving across
floor.
Failure to do so may result in
damage to floor covering.
l
Shut off electric supply to dryers.
l
Disconnect power supply cords.
Tape securely to dryer.
l
Shut off the gas supply valves in the
gas supply line.
l
Disconnect gas pipe and fittings
from dryer and cap the gas supply
line. Tape end of dryer gas pipes.
l
Tape the drums to the front panel.
l
Tape doors.
l
Adjust leveling legs all the way in.
Before installing dryers in a new
location, check with your gas supplier
or dealer to see that your dryer is
equipped with the correct burner for
the particular type of gas in your new
building. Burner information may be
found on the rating plate in the door
well of the dryer.
If you need
assistance...
The Whirlpool Consumer Assistance
Center will answer any questions
about operating or maintaining your
dryers not covered in the Installation
Instructions. The Whirlpool Consumer
Assistance Center is open 24 hours a
day, 7 days a week. Just dial l-(800)
253-l 301 - the call is free.
When you call, you will need the
dryer model number and serial
number. Both numbers can be found
on the serial/rating plate located in
the door well behind the dryer door
and on the front of the opening.