Filter
Top Products
20
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height between 60 cm and 90
cm. To keep the drain hose spout bent, use the supplied plastic hose
guide (A). Secure the guide to the wall with a hook or to the tap with a
piece of string to prevent the drain hose from moving.
(*): 60 ~ 90 cm
A
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60cm above the
ground.
ln a standpipe
We recommend using a 65 cm high vertical pipe as a standpipe. It
must be no shorter than 60 cm and no longer than 90 cm.
The standpipe drain requires:
• A minimum diameter of 5 cm.
• A minimum carry-away capacity of 60 litres per minute.
(*): 60 ~ 90 cm
STEP 5 - Powering your washing machine
Plug the power cord into a wall socket, an AC 220 - 240V / 50Hz approved electrical outlet protected by
a fuse or circuit breaker. (For more information on the electrical and grounding requirements, refer to the
"Electrical supply and grounding" section on page 14.)
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the
installation is complete.
STEP 6 - Running Calibration Mode
Your Samsung washing machine detects the weight of the laundry automatically. For a more accurate
weight detection, it is recommended running Calibration Mode immediately after installing the washing
machine. Follow the steps below to run Calibration Mode.
Before running Calibration Mode, make sure that there is nothing in the drum or on top of the
washing machine.
1. Turn the washing machine off.
2. Press the Power button while holding down the Temp. and Delay End buttons simultaneously.
The washing machine will turn on and "CLB" will appear on the display.
3. Press the Start/Pause button to start Calibration Mode.
4. The drum will rotate clockwise and counter-clockwise for about 3 minutes.
5. When Calibration Mode is complete, "End" appears on the display and the washing machine will turn
off automatically.
6. The washing machine is now ready for use.
F400E_WF70F5E_NonBubble-03262C-01_EN.indd 20 2013-01-18 �� 1:54:27