Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
Fault indicator Possible cause Remedy A
The Check drain light
flashes. "– – –" appears
in the display.
The water outlet is
blocked.
Clean the fluff filter and the
drain pump as described in
"Problem solving guide -
Opening the door in the
event of a blocked drain
outlet and/or power failure".
The drain hose has
been fixed too high.
The maximum drain height
is 1 m.
The Check inlet light
flashes. "– – –" appears
in the display.
The water inlet is
blocked.
Open the stopcock.
The filter in the water
inlet hose is dirty.
Clean the filter.
The Check inlet and
Check drain lights
flashes. "– – –" appears
in the display.
The Waterproof system
has reacted.
Call the Service
Department.
The Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence.
"– – –" appears in the
display.
There is a fault. Start the programme again.
If the fault indicators occur
again, contact the Service
Department.
ATo switch off the fault indicator: switch the washing machine off with the I-ON/
0-OFF button and turn the programme selector to
Finish
.
Problem solving guide
39