Filter
Top Products
IAdd detergent
It is important to dispense the correct
amount, because . . .
. . . too little results in the following:
–
Laundry will not be properly clean
and will in time become grey and
hard to the touch.
–
Greasy particles cling to the laundry.
–
Limescale deposits on the heater el
-
ements.
. . . too much results in the following:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an addi-
tional rinse cycle will automatically
switch in).
– A burden to the environment.
Liquid detergent
Liquid detergent should be dispensed
using a ball provided by the manufac
-
turer for programmes without a pre-
wash.
For programmes with a pre-wash you
will need to purchase a special con
-
tainer from the Miele Spare Parts de
-
partment which sits in the main wash
compartment j of the detergent dis
-
penser drawer. Add liquid detergent to
this container for the main wash and to
compartment i for the pre-wash.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i = Detergent for Pre-wash
(if selecting Pre-wash, add
1
/
4
of the total amount recom-
mended). This compartment is
also used for starch formula-
tions when starching separately.
j = Detergent for the main wash
including Soak
§ = Fabric conditioner or liquid
starch.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
JPress the START button.
This starts the programme.
How to wash correctly
24