Filter
Top Products
A fault indicator light comes on but the wash programme
continues as normal.
Fault indicator Possible cause Remedy A
The Check drain light
flashes.
The drain outlet is re
-
stricted.
Clean the fluff (drain) filter
and drain pump.
The Check inlet light
flashes.
The water inlet is re
-
stricted.
Check whether
–
the stopcock is opened
wide enough.
–
the inlet hose is kinked.
The filter in the inlet
hose is dirty.
Clean the filter.
The Excess detergent
check light comes on.
Excessive foam has
built up during wash-
ing.
Use less detergent next
time and follow the recom-
mendation on the packag-
ing.
The Main wash indicator
light flashes in the
programme sequence
display.
There is a fault. Start the programme again.
If the fault indicator occurs
again, contact the Service
Dept.
The Anti-crease/Finish
indicator light flashes in
the programme se
-
quence display.
The position of the programme selector was altered
after the start of the programme. Turn the
programme selector back to the programme previ
-
ously chosen.
ATo switch off the fault indicator: Switch off the machine with the I-ON/0-OFF but
-
ton and turn the programme selector to
Finish
.
Problem solving guide
41