A fault indicator light comes on but the wash programme con
-
tinues as normal.
Fault indicator Possible cause Remedy A
The Check drain light
flashes.
The drain outlet is
restricted.
Clean the fluff (drain) filter
and drain pump.
The Check inlet light
flashes.
The water inlet is
restricted.
Check whether
–
the stopcock is opened
wide enough.
–
the inlet hose is kinked.
The filter in the inlet
hose is dirty.
Clean the filter.
The Excess detergent
check light comes on.
Excessive foam has
built up during
washing.
Use less detergent next
time and follow the
recommendation on the
packaging.
The Main wash indicator
light flashes in the
programme sequence
display.
There is a fault. Start the programme again.
If the fault indicator occurs
again, contact the Service
Dept.
The Anti-crease/Finish
indicator light flashes in
the programme
sequence display.
The position of the programme selector was altered
after the start of the programme. Turn the
programme selector back to the programme
previously chosen.
ATo switch off the fault indicator: Switch off the machine with the I-ON/0-OFF
button and turn the programme selector to
Finish
Problem solving guide
39