The wash programme stops and a fault indicator light comes
on.
Fault indicator Possible cause Remedy A
The Check drain light
flashes.
The water outlet is
blocked.
Clean the fluff (drain)
filter and drain pump.
The drain hose has been
fixed too high.
The maximum drain
height is 1 m.
The Check inlet light
flashes.
The water inlet is blocked. Open the stopcock.
The filter in the water inlet
hose is dirty.
Clean the filter.
The Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence.
There is a fault. Start the programme
again.
If the fault indicators
occur again, contact the
Service Department.
ATo switch off the fault indicator: Switch off the machine with the I-ON/0-OFF
button and turn the programme selector to
Finish
Problem solving guide
38