Filter
Top Products
Plumbing
Connect the water supply hose (the
hose marked blue) to the cold water
valve.
Turn on the valve and check for leaks.
The water pressure must be within 14-
140 psi (0.1-1 MPa). If the water press-
ure in greater than 140 psi (1 MPa), a
pressure reducer must be installed. At
pressures below 14 psi (0.1 MPa), the
standard inlet valve of the machine
must be exchanged for a low pressure
version available from the Miele Parts
Dept.
The water supply hose is equipped
with a filter; please do not remove this
filter.
Connection to the drain sys-
tem
The 1.5 m (5 ft.) drain hose may be con-
nected as follows:
1. Directly into a sink: hook the hose
over the edge of the sink and secure
it firmly(e.g. by tieing the hose to the
water faucet).
2. Connection to a stand pipe: place the
drain hose into a 38 mm (1
1
/2")
stand pipe and firmly secure it. (An
antisiphoning device is not re-
quired;there is one built into the ma-
chine.)
3. To a floor drain: if desired, the drain
hose may be extended to 4.5 m
(15 ft.) maximum.
The machine drains using a pump with
a maximum delivery head of 1 m (4 ft.).
Make sure there are no kinks in hose.
The machine is equipped with an air-
gap/anti-siphoning system so that no
minimum drain height is required.
Plumbing
40