Problems with the load size indicator
Problem Possible cause Remedy
The display
indicates a load of
< 25% even though
the drum is full.
There was already
laundry in the drum
when the washing
machine was switched
on. This has
decalibrated the
sensor from the zero
setting.
^
To recalibrate the sensor to the
zero setting:
–
Remove the laundry from the
drum and leave the door
open
.
–
Switch off the washing
machine.
–
Switch on the washing
machine.
– Press short cut button 1. The
main menu for the Cottons
programme appears.
– Press short cut button 1
Detergent in until the display
shows:
Zero setting OK.
The display
indicates a load of
25%, 50%, 75% or
100% when the
drum is empty
The load size sensor
has been decalibrated
from the zero position.
Rotate the drum once. If the
display still indicates a load of
25%, 50%, 75% or 100%,
recalibrate the sensor to zero
again (see above section).
Problem solving guide
42