Filter
Top Products
Problem Possible cause Remedy
There are humming
noises.
The compressor is
operating.
These noises are quite
normal and do not indicate a
fault.
The display is dark.
The programme
selector is not lit up.
The Start/Stop button
light flashes slowly.
The display has
switched off
automatically to save
energy (Standby mode).
The programme selector
lighting goes out when
Settings J is selected.
The display will light up
when one of the buttons is
pressed.
The Start/Stop button
light flashes/does not
flash.
The flashing indicates
that a programme can
be started.
After the programme has
started, the flashing will
change to a constant light.
The programme does
not start.
No obvious cause. – Is the dryer switched on?
– Is the plug correctly
inserted into the socket
and switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
The display is in a
different language.
A different language has
been selected.
Set the language you want.
The flag symbol J will guide
you.
Power cut. A programme which was running previously will
continue automatically when power is restored to the
tumble dryer as long as the Cooling down phase had
not been reached.
The interior drum
lighting does not
come on.
The lighting switches off
automatically (to save
energy).
–
Switch the dryer off and
then on again.
–
If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
Problem solving guide
39