Filter
Top Products
Problem Possible cause Remedy
Clean door filter
appears at the end of a
programme.
This is a reminder to
clean the fine filters in the
door and the door
opening under running
water.
–
Clean the fine filters.
See "Cleaning and
care".
To delete the message:
–
With the appliance
switched on open and
then close the door. (If
the appliance is
switched off the
message will not go
away).
Clean plinth filter
appears at the end of a
programme.
This is a reminder to
clean the fine filter in front
of the heat exchanger unit
under running water.
–
Clean the fine filter.
See "Cleaning and
care".
To delete the message:
– Select OK.
A prompt which has not
been described
previously appears in
the display.
A programme cannot be
started while there is a
fault message in the
display.
– Make a note of what is
shown in the display.
– Switch the dryer off
and then on again.
– If a programme still
cannot be started: call
the Service
Department.
Problem solving guide
36