Filter
Top Products
Preparing the DOS dispensers
The agents can be filled into 5 l plastic
containers, which are colour coded for
the relevant dispensing system.
When first commissioning, or when the
message FILL DOS 1 CONTAINER
and/or FILL DOS 2, 3 or 4 CONTAINER
flashes in the display after switching on
or at the end of a programme, replace
the storage containers with new ones,
or refill them with the relevant agent.
If the message CHECK DISPENSING
SYSTEM 1 and/or CHECK DISPENSING
SYSTEM 2, 3 or 4 flashes in the display,
check the storage containers,
dispensing tubes and hoses. Then
replace the storage containers with new
ones, or refill them with the relevant
agent.
The programme will stop automatically.
When first commissioning or when
the message CHECK DISPENSING
SYSTEM... appears, start the
DOS-FILL Programme to vent the
dispensing system (see "Venting the
dispensing system").
,
Take great care when handling
liquid agents and additives. These
may contain irritant or corrosive
ingredients.
Please follow the manufacturer’s
safety instructions.
Wear protective gloves and
goggles.
Fill the containers with the relevant
agent
^
Switch the machine off using the
master switch.
^ Lift the service panel up and then
drop it forwards and release it from
its lower brackets.
^ Pull open the drawer to the right of
the service panel to access the liquid
supply containers.
^
Take the storage containers out,
open them and fill with the agent
required, (observe the colour code).
^
Set the service panel onto the lower
bracket and then raise it upwards
and pressing against the
washer-disinfector lower it into
position.
Dispensing liquid chemical agents
39