Filter
Top Products
Settings
107
Maximum rinse level
The water level in the rinse cycle can
be permanently set to the highest val‐
ue.
This function is useful for allergy suffer‐
ers as it achieves an excellent rinse re‐
sult. Water consumption will increase.
Factory default setting: the maximum
rinse level setting is switched off.
Suds cooling
When this is activated, additional wa‐
ter flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a tem‐
perature of 70°C or higher is selected
for the Cottons programme.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where drainage pipes do not comply
with DIN 1986.
Factory default setting: Suds cooling is
switched off.
Anti-crease
The anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
The drum continues to turn at intervals
for up to 30 minutes at the end of the
programme. The door can be opened at
any time.
Factory default setting: anti-crease is
switched on.
Delay start
For specifying which time prompt
should appear with the delay start
function.
Options
– Start at
With the Delay start function you
specify at what time the wash pro‐
gramme should begin.
– Finish at (Factory default setting)
With the Delay start function you
specify at what time the wash pro‐
gramme should end.