Filter
Top Products
If the outlet spigot has not been used
before, remove any blanking plug that may
be in place.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is formed in
the drain hose (see diagram) to prevent
waste from the sink entering the appliance.
If you intend to drain the hose from the
machine into a sink, make sure that the sink
is empty and the plug hole is not blocked.
Use the plastic “U - Piece” supplied.
Important! Before connecting up the
machine to new pipework or to pipework
that has not been used for some time, run
off a reasonable amount of water to flush
out any debris that may have collected in the
pipes.
Special conditions
If the floor is carpeted or covered with
crumbly or soft material, insert a rigid
support base under the feet to prevent
noise, vibration or displacement. The base
should protrude a few centimetres beyond
the edges of the appliance.
Warning! The appliance should
NOT be placed on deep pile
carpeting.
Note!
Please ensure that when the
appliance is installed it is easily
accessible for the engineer in the
event of a breakdown.
In the interest of the
environment
The appliance should be connected to the
FOUL drainage system, the water will then
be taken to a sewage works for treatment
before being discharged safely into a river.
It is essential that these appliances are not
connected to the surface water drainage
system as this water is discharged directly
into a river or stream and may cause
pollution.
If you require any further advice please
contact your local water authority.
36