Filter
Top Products
Select the required
programme
Turn the programme dial to the required
programme. The washing machine will
automatically select the maximum spin value
provided for the programme you have
chosen and the display will show the
duration, calculated on the basis of the
maximum load for each type of fabric.
Pressing the corresponding buttons to
change those values. The green pilot light of
the button 8 starts flashing.
The dial can be turned either clockwise or
counterclockwise. Turn to position «Off» to
reset programme/Switching the machine off.
At the end of the programme the
selector dial must be turned to
position «Off» , to switch the machine
off.
Caution! If you turn the programme
selector dial to another programme
when the machine is working, the
red pilot light of button 8 will blink 3
times to indicate a wrong selection.
The machine will not perform the
new selected programme. The
message Err is displayed for a few
seconds. The machine will not
perform the new selected
programme.
Select the spin speed or
Rinse hold option
Press button 3 repeatedly to select the
required spin speed or to select Rinse hold
option. If you select this option, the last rinse
water is not emptied out.
The relevant light will light up.
Select the desired
options
Press buttons 6 and 7 to select the available
options. Depending on the programme,
different options can be selected together.
These must be selected after choosing the
desired programme and before pressing
button 8.
If an option which is not compatible with the
set wash programme is selected, the red
button 8 light flashes 3 times and the
message Err is displayed for a few seconds.
When the option is set, the relevant light is
on.
Select the delay start
Before you start the programme, press this
button repeatedly to select the desired
delay. The set delay time value (up to 20
hours) will appear on the display for a few
seconds, then the duration of the
13