How to open the door
during the cycle of a
programme
You can open the door, after having set the
washing machine to Pause, provided the
following conditions exist:
• The washing machine is not in the heating
phase
• The level of the water is not high;
If these requirements are met, when you
pause the washing machine, the «Door
lock» light goes off and the door can be
opened.
Should it not be possible to open the door,
and should it be absolutely necessary to do
so, switch the machine off by turning the
selector dial to Off. After a few minutes,
you can open the door.
Pay attention to the level and
temperature of the water in the
washing machine! When you close the
door to restart the programme turn the dial
to the previous programme and repeat the
options previously selected and press button
8.
End of programme
At the end of the programme, the washing
machine stops automatically, the button 8
light and the Door lock light go off. The
display shows a flashing zero «0». It is
possible to open the door.
If you had selected an option that ends with
water left in the tub the Door lock light
remains lit to indicate that the water must
be drained before opening the door.
To drain or to spin follow the below
instructions:
1. Turn the programme selector dial to
Off.
2. Select the draining or spinning
programme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4.
Press button 8.
At the end of the programme, the door can
be now opened. Turn the programme
selector dial to Off to switch the machine
off.
Remove the laundry from the drum. Check
whether the drum is completely empty, by
rotating it with your hand. The purpose of
this is to prevent any items of laundry from
remaining accidentally in the drum, where
they might get damaged in a subsequent
wash (e.g. by shrinking) or bleed colour into
another load of laundry.
If you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Stand by: once the programme has
finished after a few minutes the
energy saving system is enabled with
the pilot lights switched on. By
pressing any button the appliance will
come out of the energy saving status.
15