John Lewis JLWD 1610 Washer/Dryer User Manual


 
Selection of drying time in minutes.
After starting the programme, the
remaining time is updated every minute.
If you select a drying time longer than
55 minutes, after a few seconds, the
display will show it in hours and
minutes.
Delay start, a time value indicated in
hours and selected by the relevant button.
The delay time (20 hours max) is
displayed for a few seconds, then the
duration of the selected programme
reappears. After you have pressed the
button 8, the countdown is updated every
hour, and, for the last hour, every minute.
An incorrect option selection has
been made: this is indicated by the
message Err for a few seconds when an
option incompatible with the current
programme is selected.
An alarm code indicates a fault with the
machine (see the relevant chapter).
First use
Ensure that the electrical and
water connections comply with
the installation instructions.
Remove the polystyrene block and
any material from the drum.
Before the first wash, run a cotton
cycle at the highest temperature
without any laundry in the
machine, to remove any
manufacturing residue from the
drum and tub. Pour 1/2 a measure
of detergent into the main wash
compartment and start the
machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
at the end of a washing cycle
•if there is a fault
You can deactivate the acoustic signal
(except if there is a fault) by pressing the
buttons 5 and the 6 simultaneously for
about 5 seconds. By pressing these buttons
again the acoustic signal is reactivated.
11