Filter
Top Products
programme will appear again. The wash
programme can be delayed from 30 min - 60
min - 90 min, 2 hours and then by 1 hour up
to a maximum of 20 hours.
You can cancel the delay time at any
moment, before you press the «Start/
Pause» button.
Selecting the delayed start
You must select this option after you have
set the programme and before you press the
«Start/Pause» button.
• Select the programme and the required
options.
• Select the delay start.
•
Press button 8: the machine starts its
hourly count down. The programme will
start after the selected delay has expired.
Opening the door throughout the
delay time
If you wish to add laundry in the machine
during the delay time
•
Press button 8 to put the machine in
pause.
• Add the laundry, close the door
•
Press 8 button again.
Cancelling the delayed start
•
Press button 8.
• Press «Delay start» button once until the
symbol «0’» is displayed.
•
Press button 8 again.
The Delay Start cannot be selected with the
draining programme.
Start the programme
To start the selected programme, press the
button 8 ; the green pilot light stops flashing.
If you have selected a delay time, the
countdown will begin and will be shown on
the display.
To interrupt a programme which is running,
press button 8: the green pilot light starts to
flash. To restart the programme from the
point at which it was interrupted, press the
button 8 again. If an incorrect option is
selected, the red pilot light of button 8
flashes 3 times and the message Err is
displayed for a few seconds.
Important!
You must set the washing machine to Pause
before you make any change in the
programme in progress.
How to change an option
or a programme during
its cycle
It is possible to change some options
before the programme carries them out.
Before you make any change, you must
pause the washing machine by pressing the
button 8. Changing a running programme is
possible only by resetting it.
Turn the programme selector dial to «Off»
and then to the new programme position.
Start the new programme by pressing the
button 8. The washing water in the tub will
not empty out
How to interrupt a
programme
Press the button 8 to interrupt a
programme which is running, the
corresponding green pilot light starts
blinking.
Press the same button again to restart the
programme.
14