15
First time installation
be shown. This is usually BBC1. An information banner will appear along the top of
the picture for a short time which gives basic details of the TV programme you are
watching.
Problems installing the channels
If you could not receive any channels as described previously, do the following.
Check all the connections to your set-top box and TV making sure the connections •
are secure and connected to the correct sockets.
Try the installation again by following the ‘Retuning procedure’ given on page 30.•
How to turn the set-top box off
If you watch TV regularly, you should leave the set-top box in standby mode when you
are not watching TV. You should only switch it off at the mains if you are away or do not
want to use the TV for a long time, one month for example.
Your set-top box will automatically update the stored channels while it is standby mode
as they become available. It can also receive updates to the operating software during
this time. It cannot receive new channels and software updates when the set-top box is
disconnected from the mains supply or the aerial is disconnected.
If you plan to disconnect the set-top box from the mains, you should put it into standby
first.
You can put the set-top box on standby as follows.
Press the button labelled 1 stb.
The front panel power indicator will change colour from green to red. 2
The set-top box is now in standby mode.3
The set-top box ‘Scart’ output will now be turned off.4
The TV picture will be turned off.5
How to turn the set-top box on from standby
Press the button labelled 1 stb.
The front panel power indicator will change colour from red to green.2
This will turn on the set-top box Scart output.3
The TV picture will turn on and show the station that you were watching when the 4
set-top box was put on standby.
Goodmans GDB20TTS_Instruction Manual.indb 15 6/15/2010 4:26:30 PM