Filter
Top Products
With the appliance installed adjust all four feet ensuring the machine
is stable, and a clearance of approximately 5 mm is left between the
top of the machine and the underside of the worktop.
A final check for stability should be carried out with the machine on
spin with a load, this will identify the need for any further fine adjust-
ment to the feet.
A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D
must be screwed down into the base directly in front of the machine’s
feet, this will provide additional security.
If required an additional door magnet, part number 1242394-00/3 and
disc, part number 1242393-00/5 are available from spare parts.
58
Building-in