Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
AJ0976
16
Break-In Adjustments
As new press is used, working surfaces “seat-in” and
friction decreases. This usually results in increased
working speed.
These conditions are considered normal in a new press
and do not indicate a need for constant maintenance.
This initial “break-in” period will vary with usage, but
generally occurs during the first week of operation. At
this time the following items should be inspected and
adjusted if necessary.
1. Recheck the level of press. This is especially
important if press is located on wooden flooring.
2. Simultaneously press both buck in buttons to
send buck into cabinet and close heads. Check
alignment of collar block in head cutout. Check
snorkel alignment. Refer to
Figure 6. Make
adjustments if required.
3. Adjust buck in travel speed. If buck is traveling
too fast or bottoms out shock absorber, slow
indexing cylinder down.
4. Check operation of all operating controls.
5. Inspect press for loose bolts, screws, pipe fittings
and carriage rollers, especially on the buck
carriage.
To AVOID possible serious injury, BEFORE
performing maintenance or repair tasks:
• Shut off AND lock out ALL electric power
to the press.
• Shut off AND lock out ALL steam service
to the press.
• Allow heated surfaces to cool.
W334
WARNING