Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
9
AJ0976
Receiving Inspection
The press is shipped assembled and enclosed in a
plastic cover and crate. Upon delivery, inspect crate
and contents for shipping damage. If crate or cover is
damaged, or signs of possible damage are evident,
have carrier note the condition on the shipping papers
before shipping receipt is signed, or advise carrier of
condition when discovered.
Remove protective cover and check items received
against items listed on packing list. If any item is
damaged or missing, a written claim should be filed
with the carrier as soon as possible.
Moving and Locating Press
IMPORTANT: If a forklift is used to move the
press, exercise care that forklift arms are inserted
under the frame and do not contact any operating
mechanism.
Move press to the installation location while it is still
attached to skid. However, press can be removed from
skid before moving.
To remove unit from skid, unscrew the four shipping
cap screws from the attaching holes and work press
from skid.
Press should be located in an area that provides a
minimum of 24 inches (61 cm) between press and any
structure.
IMPORTANT: The above dimensions are
considered minimum working and maintenance
dimensions and should be increased if possible.
Foundation Requirements
Install press on a solid, level floor such as concrete.
IMPORTANT: Installation on a wooden floor can
cause machine to shift, which will result in
misalignment of heads and bucks and damage to
both press and garments.
Floor should be capable of supporting 125 pounds
(56.7 kilograms) per square foot. Remove all floor
covering material (tile, wood, carpeting, etc.) from
press mounting area.
Uncrating
1. Remove wooden crate. Move the press to area of
final location and remove wooden skid. Remove
all panels.
2. Install left end guard using attached hardware
before opening press heads. Refer to Figure 1 for
location if needed.
3. Remove any shipping material on heads and
buck.
4. Carefully remove any shipping braces using a
hammer or any long-handled striking device, to
knock shipping braces away from unit. Avoid
using excessive force to remove brace. Excessive
force applied to the braces can result in damage
to unit and/or alignment of internal parts.
To avoid possible serious injury:
• ALWAYS be careful to AVOID spring-
loaded components when working inside
press.
• Installation MUST be performed ONLY by
qualified service personnel.
W336
WARNING