Filter
Top Products
35 / EN
Washing Machine / User’s Manual
4.7.3 Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
4.7.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the machine and also
at the end of each water intake hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the washing machine. Filters
should be cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake
valves. Clean them with an appropriate brush. If the filters are too dirty, remove them
from their places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water.
4. Replace the seals and filters carefully and tighten their nuts by hand.
4.7.5 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric
fibers clogging the pump impeller during discharge of washing water. Thus, the water will
be discharged without any problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months. Water must be drained off first to clean the
pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in
case of freezing of the water, water may have to be drained completely.
A
CAUTION: Foreign substances left in the pump filter may damage your machine or may cause
noise problem.
CAUTION: If the product is not being used, shut the tap shut, remove mains pipe and drain the
water inside the machine against any likely freezing.
CAUTION: After each use, turn off the water tap to which the mains hose is connected.
In order to clean the dirty filter and discharge the water:
1 Unplug the machine to cut off the supply power.
A
CAUTION: Temperature of the water inside the machine may rise up to 90 ºC. To avoid the burning
risk, clean the filter after the water inside the machine is cooled down.