Filter
Top Products
34 / EN
Washing Machine / User’s Manual
4.7 Maintenance and cleaning
Service life of product extends and frequently experienced problems will be reduced if it is
cleaned at regular intervals.
4.7.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to prevent
accumulation of powder detergent in time.
Lift the rear part of the siphon to remove it as illustrated.
If more than normal amount of water and softener mixture
starts to gather in the softener compartment, the siphon
must be cleaned.
1 Press the dotted point on the siphon in the softener compartment and pull towards
you until the compartment is removed from the machine.
2. Wash the detergent drawer and the siphon with plenty of lukewarm water in a
washbasin. In order to prevent the residues to contact your skin, clean it with an
appropriate brush by wearing a pair of gloves.
3 Insert the drawer back into its place after cleaning and make sure that it is seated
well.
4.7.2 Cleaning the loading door and the drum
Residues of softener, detergent and dirt may accumulate in your machine in time and
may cause unpleasant odours and washing complaints. To avoid this, use the Drum
Cleaning programme. If your machine is not featured with Drum Cleaning programme,
use Cottons-90 programme and select Additional Water or Extra Rinse auxiliary
functions as well. Run the programme without any laundry in the machine. Before starting
the programme, put max. 100 g of powder anti-limescale into the main wash detergent
compartment (compartment nr. "2"). If the anti-limescale is in tablet form, put only one
tablet into compartment nr. 2. Dry the inside of the bellow with a clean piece of cloth after
the programme has come to an end.
C
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing machines.
After every washing make sure that no foreign substance is
left in the drum.
If the holes on the bellow shown in the figure is blocked,
open the holes using a toothpick.
Foreign metal substances will cause rust stains in the
drum. Clean the stains on the drum surface by using
cleaning agents for stainless steel.
Never use steel wool or wire wool. These will damage the
painted, chromated and plastic surfaces.