12 / EN
Washing Machine / User’s Manual
4.4 Installation
• Apply to the nearest authorized service agent for the installation of your product.
• Preparation of the location and electrical, tap water and waste water installations at the
place of installation is under customer's responsibility.
• Make sure that the water inlet and discharge hoses as well as the power cable are not
folded, pinched or crushed while pushing the product into its place after installation or
cleaning procedures.
• Make sure that the installation and electrical connections of the product are performed
by authorized service. Manufacturer shall not be held liable for damages that may arise
from procedures carried out by unauthorized persons.
• Prior to installation, visually check if the product has any defects on it. If so, do not have
it installed. Damaged products cause risks for your safety.
4.4.1 Appropriate installation location
• Place the product on a hard and level floor. Do not put it onto a carpet with high pile or
other similar surfaces.
• When the washing machine and drier are placed on top of each other, their total weight
–when loaded– amounts to 180 kilograms. Place the product on a solid and flat floor
that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product in the environments where the temperature falls below 0 ºC.
• Leave a minimum space of 1 cm between the machine and the furniture.
• On a graduated floor, do not place the product next to the edge or on a platform.
4.4.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by
pulling the ribbon. Do not make this operation alone by
yourself.
4.4.3 Removing the transportation locks
1 Loose all bolts with an appropriate wrench until they turn freely (C).
2 Remove the transport safety bolts by turning them slightly.
3 Insert the plastic covers in the bag containing the user manual to the openings on the
rear panel. (P)