Filter
Top Products
15
c. Annunciator, Pendent, Over-Burner, and RTD (Resistive Temperature Device) Cable
Remove the four (4) bolts that hold on the character (464) panel. Open the door to the main electrical
enclosure, the female end of the RTD (Resistance Temperature Device) cable will be found there. Loosen
the 1-inch lock nut and remove the modified hole seal. Put the female end of the RTD cable through the
hole in the top of the electrical enclosure. Connect the male end and the female end of the RTD cable
together, pull the cable up until the threads of the reducing bushing can be seen through the hole into where
the character (464) panel was. Next, get the 1-inch lock nut on by a few threads, slip the modified hole
seal under the lock nut holding the 45° cord grip connector, then tighten the 1-inch lock nut. Replace the
character (464) panel and tighten the four (4) bolts.